ERROR: rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)

[hanshasn12345678]

Hello everyone!

I'm beginner with the ESP32,
I'm trying show values of a 3 pin Photosensitive sensor with the ESP32 DevKitV1 in the monitor serie but in the moment of compile the program and see the monitor serie appear a next message:

error.png (21.53 KiB) Viewed 14781 times

My code is:

int sensorValue;

void setup()
{
Serial.begin(9600); // starts the serial port at 9600
}

void loop()
{
sensorValue = analogRead(25); // read analog input pin D25 of the ESP32
Serial.print(sensorValue, DEC); // prints the value read
Serial.print(" \n"); // prints a space between the numbers
delay(1000); // wait 100ms for next reading
}

I have conected the DO pin on D25 of ESP32 pin, pin GND on the GND and VCC pin on 3v3.

I tried erase the flash with flash_download_tool_3.8.8 without lucky

Thanks.

[ullixesp]

I'd suggest to first remove all connections and try to run. If this runs, check whether you were using the correct pins.

Erasing the flash is best done with an ESP-IDF tool available in all ESP* frameworks: `esptool.py erase_flash`. (Sometimes helpful also `esptool.py flash_id`).

[hanshasn12345678]

I'd suggest to first remove all connections and try to run. If this runs, check whether you were using the correct pins.

Erasing the flash is best done with an ESP-IDF tool available in all ESP* frameworks: `esptool.py erase_flash`. (Sometimes helpful also `esptool.py flash_id`).

Thanks for the suggest, i could already fix the problem

[kvaziigor]

I'd suggest to first remove all connections and try to run. If this runs, check whether you were using the correct pins.

Erasing the flash is best done with an ESP-IDF tool available in all ESP* frameworks: `esptool.py erase_flash`. (Sometimes helpful also `esptool.py flash_id`).

Thanks for the suggest, i could already fix the problem

how You fix this problem, i have the same(